|
Question |
Rating |
View Answer |
|
Which one of the following is an AutoCAD relative polar co-ordinate |
|
View Answer |
|
ou are designing a floor plan and know the length and angle of one of the wall segments to be 1500mm and 30 degrees. This is to be followed by a wall 2000mm long at 90 degrees to the first. Which one of the following is the correct input? |
|
View Answer |
|
Which one of the following would draw a vertical line 30 units in length from a previously defined point given as 30,50? |
|
View Answer |
|
The shape above is based on a 10 unit module. which is the correct set of codes to draw this shape, starting at the lower left and moving anti clock wise |
|
View Answer |
|
There are at least eleven options to the "select objects" prompt. Which of the following has an incorrect option? |
|
View Answer |
|
When using the move command to move a single object by a given distance, which is the best of the following methods? |
|
View Answer |
|
The "select object" option "Previous" is best described by |
|
View Answer |
|
The following two commands used one after the other BOUNDARY then pick inside an area ERASE ALL R LAST produces which of these results |
|
View Answer |
|
Which one of the following system variables disables the prompt which asks for attribute values, and causes attributes to be set to their defaults? |
|
View Answer |
|
What is the significance of using the command WBLOCK? |
|
View Answer |
|
The effect of the EXPLODE command when applied to a block is to? |
|
View Answer |
|
The use of blocks allows libraries of standard parts to be developed and saved for latter use. Blocks may be stored |
|
View Answer |
|
Which one of the following methods should be used to repeat a complex part in a drawing in order to minimise file size? |
|
View Answer |
|
Which one of the following is a correct statement regarding AutoCAD blocks? |
|
View Answer |
|
The SETVAR command is used to? |
|
View Answer |
|
If the system variable MIRRTEXT is set to 1, text is |
|
View Answer |
|
Which one of the following allows the value of the system variable PICKBOX to be changed whilst in the ERASE command? |
|
View Answer |
|
Which one of the following system variables determines the visibility of the control points of a pline spline curve? |
|
View Answer |
|
The system variable SPLINETYPE determines? |
|
View Answer |
|
Which of the following system variables controls the accuracy of approximation of a spline curve? |
|
View Answer |