|
INTERVIEW QUESTIONS
WEB
AUTOCAD
DETAILS
Question: Which one of the following would draw a vertical line 30 units in length from a previously defined point given as 30,50?
Answer: (a) 60,50 (b) 30,80 (c) @30,0 (d) @30<0
|
|
|
Category |
Autocad Interview Questions & Answers -
Exam Mode /
Learning Mode
|
Rating |
(0.3) By 6507 users |
Added on |
9/22/2014 |
Views |
66868 |
Rate it! |
|
|
Question:
Which one of the following would draw a vertical line 30 units in length from a previously defined point given as 30,50?
Answer:
(a) 60,50 (b) 30,80 (c) @30,0 (d) @30<0 Source: CoolInterview.com
If you have the better answer, then send it to us. We will display your answer after the approval.
Rules to Post Answers in CoolInterview.com:-
- There should not be any Spelling Mistakes.
- There should not be any Gramatical Errors.
- Answers must not contain any bad words.
- Answers should not be the repeat of same answer, already approved.
- Answer should be complete in itself.
|
|
Related Questions |
View Answer |
|
ou are designing a floor plan and know the length and angle of one of the wall segments to be 1500mm and 30 degrees. This is to be followed by a wall 2000mm long at 90 degrees to the first. Which one of the following is the correct input?
|
View Answer
|
|
Which one of the following is an AutoCAD relative polar co-ordinate
|
View Answer
|
|
To continue drawing a line from the last known point, enter
|
View Answer
|
|
When drawing a digital watch measuring 30mm x 25mm, which one of the following would be the BEST set of drawing limits to use?
|
View Answer
|
|
Which one of the following is an AutoCAD absolute point co-ordinate?
|
View Answer
|
|
The position of a mouse on a surface is NOT directly related to the position of the screen cursor. This makes the mouse unsuitable for
|
View Answer
|
|
Absolute co ordinates are measured from the
|
View Answer
|
|
Which one of the following best describes a "user co-ordinate System"?
|
View Answer
|
|
When designing an integrated circuit measuring 5mm x 5mm the measurements should be entered using a scale of
|
View Answer
|
|
Which one of the following key combinations will toggle COORDS?
|
View Answer
|
|
Which one of the following key combinations will toggle SNAP?
|
View Answer
|
|
Which of the following statements is true?
|
View Answer
|
|
Which of the following key combinations issues the ISOPLANE command?
|
View Answer
|
|
The shortcuts or command alias that allows us to key in L and AutoCAD responds with LINE are stored in a file named
|
View Answer
|
|
Which one of the following key combinations is a standard windoze short cut that does not relate to the clipboard.
|
View Answer
|
|
The line types definitions are stored on the system with an extension of?
|
View Answer
|
|
Which one of the following could be an AutoCad drawing file?
|
View Answer
|
|
Which one of the following is the AutoCAD filename extension used to indicate a compiled text font?
|
View Answer
|
|
The special character string that is used to print the diameter sign is
|
View Answer
|
|
When is a space NOT interpreted as the enter key?
|
View Answer
|