CoolInterview.com - World's Largest Collection of Interview Questions
Start Your Own website Now
Sponsored Links

Interview Questions
Our Services

Get 9,000 Interview Questions & Answers in an eBook.


  • 9500+ Pages
  • 9000 Question & Answers
  • All Tech. Categories
  • 14 MB Content

    Get it now !!



    Send your Resume to 6000 Companies


  • Advertisements Electrical & Electronics Engineering(EEE) Interview Questions
    COOLINTERVIEW.COM ELECTRICAL & ELECTRONICS ENGINEERING(EEE) INTERVIEW QUESTIONS QUESTIONS LISTING

    Electrical & Electronics Engineering(EEE) Interview Questions & Answers

    Below we have listed all the Electrical & Electronics Engineering(EEE) Interview Questions and answers. Feel free to comment on any Electrical & Electronics Engineering(EEE) Interview Questions or answer by the comment feature available on the page.

    To buy an eBook containing 9000 Interview Questions, with Answers, Click Here.

    Previous 1 2 3 4 5 6 7 8 9 10 11 12 13 Next

    Sort By :   Latest First  |  Oldest First  |  By Rating

    Question
    Rating
    View Answer
    an ean efficient transformer should have (a).less copper losses (b)less iron losses (c)less eddy current losses (d)all the above
    View Answer
    The internal resistance of a 30,000 ohm/volt voltmeter set on its 50 V range is A. 15,000 B. 150,000 C. 1,500,000 D. 15,000,000
    View Answer
    In a three-phase system, the voltages are separated by A. 45? B. 90? C. 120? D. 180?
    View Answer
    Referring to the give circuit, the output will A.ecay to zero at the end of the pulse Breach 6 V at the end of the pulse C. reach 3.78 V at the end of the pulse D. reach 5.16 V at the end of the pulse
    View Answer
    What is the reluctance of the circuit in problem 9 if the flux is 275 Wb? A. 0.0066 At/Wb B. 0.066 At/Wb C. 8,727 At/Wb D. 872 At/Wb
    View Answer
    For a given wirewound core, an increase in current through the coil A. reverses the flux lines B. decreases the flux density C. increases the flux density D. causes no change in flux density
    View Answer
    A 12 k resistor, a 15 k resistor, and a 22 k resistor are in series with two 10 k resistors that are in parallel. The source voltage is 75 V. Current through the 15 k resistor is approximately A. 14 mA B. 1.4 mA C. 5 mA D. 50 mA
    View Answer
    The Norton equivalent current is A.the current through the load B.the open-current from the source C.the short circuit current D.none of the above
    View Answer
    Two 1.2 k resistors are in series and this series combination is in parallel with a 3.3 k resistor. The total resistance is A. 138 B. 1,389 C. 5,700 D. 880
    View Answer
    A 33 half-watt resistor and a 330 half-watt resistor are connected across a 12 V source. Which one(s) will overheat? A. 33 B. 330 C. both resistors D. neither resistor
    View Answer
    A balanced Wheatstone bridge consists of an RV of 3,500 , an R2 of 200 , and an R3 of 680 . The value of RUNK is A. 680 B. 1,029 C. 200 D. 880
    View Answer
    What is skin effect?
    View Answer
    An ohmmeter is an instrument for measuring A. current B. voltage C. resistance D. wattage
    View Answer
    To understand how the output voltage is shaped by a differentiator, you must consider A. the response to the rising pulse edge B. the response between the rising and falling edges C. the response to the falling pulse edge D. all of the above
    View Answer
    . A certain transformer has a turns ratio of 1 and a 0.85 coefficient of coupling. When 2 V ac is applied to the primary, the secondary voltage is A. 1.7 V B. 0.85 V C. 1 V D. 0 V
    View Answer
    Electrons in the outer orbit are called A. nuclei B. valences C. waves D. shells
    View Answer
    In electronic systems, repetitive-pulse waveforms are encountered A. more often than single pulses B. less often than single pulses C. about as often as single pulses D. twice as often as single pulses
    View Answer
    A given power supply is capable of providing 6 A for 3.5 h. Its ampere-hour rating is A. 0.58 Ah B. 2.1 Ah C. 21 Ah D. 58 Ah
    View Answer
    To step 110 V ac down to 20 V ac, the turns ratio must be A. 5.5 B. 18 C. 0.18 D. 0.018
    View Answer
    A thermistor is a type of A. switch B. resistor C. battery D. power supply
    View Answer

    Previous 1 2 3 4 5 6 7 8 9 10 11 12 13 Next

    A D V E R T I S E M E N T





    User Options
    Sponsored Links


    Copyright ©2003-2015 CoolInterview.com, All Rights Reserved.
    Privacy Policy | Terms and Conditions

    Download Yahoo Messenger | Placement Papers| FREE SMS | ASP .Net Tutorial | Web Hosting | Dedicated Servers | C Interview Questions & Answers

    Testing Articles | Testing Books | Testing Certifications | Testing FAQs | Testing Downloads | Testing Interview Questions | Testing Jobs | Testing Training Institutes


    Cache = 0 Seconds