CoolInterview.com - World's Largest Collection of Interview Questions & Answers, FAQs, queries, sample papers, exam papers, dumps, what, why, how, where, when questions
Interview Success Kit - Get Success in Job Interviews Interview Success Kit - 30,000 Interview Que. & Ans.
Covers 30,000+ Interview Questions asked in actual MNC Interviews - all with model answers.
Get Your Dream Job Now - www.vyoms.com
Sponsored Links
Interview Questions
Our Services

INTERVIEW QUESTIONS CISCO CERTIFICATION EXAMS CCDA CERTIFICATION EXAM DETAILS
Question :
Which two of these best describe the implementation of a WAN Backup
design over the Internet? (Choose two.)
A. a best-effort method
B. requires no ISP coordination or involvement
C. bandwidth guaranteed based on interface configuration
D. designed as an alternative to a failed WAN connection
E. implemented with a point-to-point logical link using a Layer 2 tunnel

Category CCDA Certification Exam Interview Questions
Rating (3.0) By 22 users
Added on 7/22/2015
Views 20
Rate it!
Answers:

A.a best-effort method

D.designed as an alternative to a failed WAN connection



If you have the better answer, then send it to us. We will display your answer after the approval.
Rules to Post Answers in CoolInterview.com:-

  • There should not be any Spelling Mistakes.
  • There should not be any Gramatical Errors.
  • Answers must not contain any bad words.
  • Answers should not be the repeat of same answer, already approved.
  • Answer should be complete in itself.
  • Name :*
    Email Id :*
    Answer :*
    Verification Code Code Image - Please contact webmaster if you have problems seeing this image code Not readable? Load New Code
    Process Verification Enter the above shown code: *
    Inform me about updated answers to this question

    Related Questions
    View Answer
    You are designing a small branch office that requires these attributes:
    support for 60 users
    the growth capacity to add another 15 users soon
    redundant access
    higher bandwidth between the Layer 2 switch and routing to the WAN
    Which branch office topology or technology must be used?
    A. two-tier
    B. loop-free
    C. three-tier
    D. EtherChannel
    E. integrated routing and switching
    View Answer
    A Cisco security mechanism has the following attributes:
    it is a sensor appliance
    it searches for potential attacks by capturing and analyzing traffic
    it is a "purpose-built device"
    it is installed passively
    it introduces no delay or overhead
    Which Cisco security mechanism is this?
    A. IKE
    B. PIX
    C. HIPS
    D. NIDS
    E. HMAC
    View Answer
    Which two techniques can reduce voice packet transfer delay across a link
    of less than 512 kbps? (Choose two.)
    A. deploy LFI
    B. increase queue depth
    C. increase link bandwidth
    D. extend the trust boundary
    E. deploy software compression
    View Answer
    The topology map in the draft design document should cover which two
    layers of the OSI model? (Choose two.)
    A. physical
    B. data link
    C. network
    D. transport
    E. session
    F. application

    View Answer
    A company is designing a worldwide IPv6 network with duplicated file
    servers at multiple locations. Each file server contains identical reference information. Which IPv6
    address type would be used to allow each end station to send a request to the nearest file server using the
    same destination address, regardless of the location of that end station?
    A. unicast
    B. anycast
    C. multicast
    D. broadcast
    View Answer
    Which H.323 protocol controls call setup between endpoints?
    A. H.225
    B. H.245
    C. RAS
    D. RTCP
    View Answer
    Which two VoIP characteristics are affected most by codec choice? (Choose
    two.)
    A. voice quality
    B. silent packet handling
    C. voice packet header size
    D. bandwidth required for voice calls
    View Answer
    Which two of these are required for wireless client mobility deployment
    when using a Cisco Unified Wireless Network? (Choose two.)
    A. assigned master controller
    B. matching mobility group name
    C. matching RF group name
    D. matching RF power
    E. matching security
    F. matching RF channel
    View Answer
    Which two statements represent advantages that the top-down network
    design process has over the bottom-up network design process? (Choose two.)
    A. is able to provide the big picture
    B. utilizes previous experience
    C. takes less time to design a network
    D. identifies appropriate technologies first
    E. provides a design for current and future development
    View Answer
    Which two of these represent a best practice implementation of a Split MAC
    LWAPP deployment in a Cisco Unified Wireless Network? (Choose two.)
    A. Each wireless client authentication type maps to a shared SSID which in turn maps to a common shared
    VLAN.
    B. Each wireless client authentication type maps to a unique SSID which in turn maps to a unique VLAN.
    C. Each wireless client authentication type maps to a unique SSID which in turn maps to a common shared
    VLAN.
    D. 802.1Q trunking extends from the wired infrastructure to the access point for translation into SSID(s).
    E. 802.1Q trunking extends from the wired infrastructure to a wireless LAN controller for translation into
    SSID(s).
    F. 802.1Q trunking extends from the wired infrastructure to a wireless LAN controller. Then the 802.1Q
    packet is encapsulated in LWAPP and sent to the access point for transmission over the SSID(s).
    View Answer
    An organization needs a WAN Transport technology that meets these
    criteria:
    has a low initial cost
    provides low-to-medium BW
    has medium-to-high latency and jitter
    Which technology would you suggest?
    A. DSL
    B. X.25
    C. ISDN
    D. wireless
    E. analog modem
    View Answer
    Which three factors best justify WAN link redundancy between
    geographically dispersed sites? (Choose three.)
    A. important traffic flows
    B. lack of speed
    C. high link utilization
    D. uncertain reliability
    E. excessive packet transmission rate
    F. high expense of transmitting data
    View Answer
    Which statement accurately describes one difference between a small office
    and medium office topology?
    A. Small offices commonly use Rapid PVST+ for Layer 3 deployments.
    B. Medium offices commonly use integrated route and switching platforms.
    C. Medium offices use integrated 10/100/1000 interfaces as Layer 2 trunks.
    D. Medium offices use external access switches to support LAN connectivity.
    View Answer
    Which two VoIP characteristics are affected most by codec choice? (Choose two.)
    A. voice quality
    B. silent packet handling
    C. voice packet header size
    D. bandwidth required for voice calls
    View Answer
    Which two of these are required for wireless client mobility deployment when using a Cisco Unified Wireless
    Network? (Choose two.)
    A. assigned master controller
    B. matching mobility group name
    C. matching RF group name
    D. matching RF power
    E. matching security
    F. matching RF channel
    View Answer
    Which two statements represent advantages that the top-down network design process has over the bottom-up
    network design process? (Choose two.)
    A. is able to provide the big picture
    B. utilizes previous experience
    C. takes less time to design a network
    D. identifies appropriate technologies first
    E. provides a design for current and future development
    View Answer
    Which two of these represent a best practice implementation of a Split MAC LWAPP deployment in a Cisco
    Unified Wireless Network? (Choose two.)
    A. Each wireless client authentication type maps to a shared SSID which in turn maps to a common shared
    VLAN.
    B. Each wireless client authentication type maps to a unique SSID which in turn maps to a unique VLAN.
    C. Each wireless client authentication type maps to a unique SSID which in turn maps to a common shared
    VLAN.
    D. 802.1Q trunking extends from the wired infrastructure to the access point for translation into SSID(s).
    E. 802.1Q trunking extends from the wired infrastructure to a wireless LAN controller for translation into
    SSID(s).
    F. 802.1Q trunking extends from the wired infrastructure to a wireless LAN controller. Then the 802.1Q packet is
    encapsulated in LWAPP and sent to the access point for transmission over the SSID(s).
    View Answer
    Which three factors best justify WAN link redundancy between geographically dispersed sites? (Choose three.)
    A. important traffic flows
    B. lack of speed
    C. high link utilization
    D. uncertain reliability
    E. excessive packet transmission rate
    F. high expense of transmitting data
    View Answer
    Which statement accurately describes one difference between a small office and medium office topology?
    A. Small offices commonly use Rapid PVST+ for Layer 3 deployments.
    B. Medium offices commonly use integrated route and switching platforms.
    C. Medium offices use integrated 10/100/1000 interfaces as Layer 2 trunks.
    D. Medium offices use external access switches to support LAN connectivity.
    View Answer

    Please Note: We keep on updating better answers to this site. In case you are looking for Jobs, Pls Click Here Vyoms.com - Best Freshers & Experienced Jobs Website.

    View ALL CCDA Certification Exam Interview Questions & Answers

    User Options
    Latest 20 Questions
    How to Retrieve a Cookie Value ?
    How to Create a Cookie?
    What is ViewState ?
    What are different methods of session maintenance in ASP.NET?
    What is cross cutting concern and concern in spring AOP ?
    What are the important beans lifecycle methods ?
    Explain the advantages of using DAO module?
    What is SQLProvider ?
    How struts application can be integrated with spring?
    What are the advantages of spring framework?
    What is ?Throws advice? in Spring ?
    What is Metadata Autoproxying ?
    Describe about DAO in Spring framework ?
    What is called an Advice ?
    What is IOC?
    What are the types of Dependency Injection?
    What are the different Modes of Autowiring ?
    Define Application context module?
    Why Spring framework is needed?
    What is called Spring MVC?


    Copyright ©2003-2016 CoolInterview.com, All Rights Reserved.
    Privacy Policy | Terms and Conditions

    Download Yahoo Messenger | Placement Papers| FREE SMS | ASP .Net Tutorial | Web Hosting | Dedicated Servers | C Interview Questions & Answers

    Testing Articles | Testing Books | Testing Certifications | Testing FAQs | Testing Downloads | Testing Interview Questions | Testing Jobs | Testing Training Institutes


    Cache = 0.628906 Seconds